Tuesday, 21 July 2015

Progress update - Data, vents, tv wiring etc...

Hi All,

Our heating and cooling vents are going in today. Unfortunately, the bright spark that cut the plaster managed cut the hole a little too big on one of the vents. Let's see how they are going to fix this one.





Other things that happened/happening on site are. Data (Argus), TV pre-wiring, roof panel/gutter repairs etc... Going so fast and getting so close now! 









Posted by at
Labels: , , , , , ,

9 comments:

  1. knyght21 July 2015 at 19:44

    Hey Joe, we have the same issue with 2 vents. I'll leave it for my SS to correct and see how it looks at PCI.

    Good to see things are progressing nicely. Great outcome with the front taps also... especially since it didn't cost anything!

    ReplyDelete
    Replies
    1. Unknown21 July 2015 at 19:48

      Hi Troy, thanks for letting me know. It was really disappointing to see. Yea we've agreed to do the same. If you find out how they fix yours please let me know.

      Thanks very much, we can't wait to move in. Yea, I was very relieved when they agreed to move them especially without any charge to us :D

      Delete
  2. Unknown22 July 2015 at 16:00

    Hi Joe,

    I am currently building the Dunedin 31 in Trillium and they have used the incorrect hinge's and draw runners in our kitchen. If you got the kitchen upgrade pack they are suppose to upgrade the hinges and draw runners to the more expensive "Blum" brand rather than the cheaper Hettick brand. Probably worth a check to make sure your getting what you paid for.

    Great job on the blog by the way :)

    ReplyDelete
    Replies
    1. Unknown22 July 2015 at 16:03

      Hi Matt,

      Thanks for the heads up! Didn't know that. Do you know how we can tell the difference? Do you have photos?

      Thanks :D

      Delete
  3. Unknown22 July 2015 at 16:17

    Hi Joe,

    Best thing to do would be to inspect the hinges/soft close and check the brand, my partner works in the kitchen industry are told me the blum ones are quite a bit more expensive. I do have a photo but i can't post it as a comment, just look at the circle bit of the hinge that's where the brand should be.

    thanks

    ReplyDelete
    Replies
    1. Unknown22 July 2015 at 16:20

      Hi Matt,

      Great thanks again.

      Delete
    2. Unknown26 July 2015 at 09:15

      Matt,

      You were right they installed hettich brand and our original brochure says Blum. Did they end up replacing yours? Who did you raise the issue to..BC?

      I noticed they since delete the word 'Blum' from all the contracts, brochures etc... must be too much $$ to install.

      Cheers.

      Delete
  4. Unknown28 July 2015 at 08:48

    Hi Joe,

    i raised this with my SS, and am in discussion to have them replaced, i really think they don't want to replace them because it would be expensive. Mayby they could offer us some kind or credit? not sure at this stage.

    ReplyDelete
    Replies
    1. Unknown28 July 2015 at 08:53

      Hi Matt,

      Thanks for the feedback. I have done the same. I doubt they will replace them but worth a shot.

      Will keep you updated.

      Thank you,
      Joe

      Delete

Subscribe to: Post Comments (Atom)